LEMON Manuals: Even more car manuals for everyone
Home >> Acura >> 2005 >> MDX Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 77 (Fuel Supply System) >> Fuel Tank Replacement

Fuel Tank Replacement

WARNING: This page is about a different car, the 2009 Acura MDX, 2008 Acura MDX, and 2007 Acura MDX. However, it is still accessible from the selected car via links, so may be relevant.
  1. Relieve the fuel pressure (see FUEL PRESSURE RELIEVING  ).
  2. Drain the fuel tank (see FUEL TANK DRAINING  ), then disconnect the fuel tank unit 4P connector and the quick-connect fittings from the fuel tank unit.
  3. Raise the vehicle on a lift.
  4. Remove the exhaust pipe (see EXHAUST PIPE AND MUFFLER REPLACEMENT ).
  5. Remove the propeller shaft (see PROPELLER SHAFT REMOVAL ), and support it with jackstands.
  6. Remove the fuel tank guard (A) and fuel tank protector (B).
    Fig 1: Fuel Tank Guard, Fuel Tank Protector, Clamp And Hoses With Torque Specifications
    G05485286Courtesy of AMERICAN HONDA MOTOR CO., INC.
  7. Loosen the clamp (C), and disconnect the tube (D). Slide back the clamps, then twist the hoses as you pull to avoid damaging them.
  8. Open the clamps (E).
  9. Disconnect the hoses (F).
  10. Place a jack or other support under the fuel tank (G).
  11. Remove the strap bolts and the straps (H).
  12. Remove the fuel tank.
  13. Install the parts in the reverse order of removal.
scientia non olet · About LEMON Manuals