LEMON Manuals: Even more car manuals for everyone
Home >> Acura >> 2005 >> MDX Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 130 (Keyless/Power Door Locks/Security System) >> Door Lock Knob Switch Test >> Passenger Doors

Passenger Doors

WARNING: This page is about a different car, the 2009 Acura MDX, 2008 Acura MDX, and 2007 Acura MDX. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the passenger's door panel (see FRONT DOOR PANEL REMOVAL/INSTALLATION ).
  2. Disconnect the 10P connector (A) from the actuator (B).
    NOTE: The illustration shows the front passenger's door.
    Fig 1: Identifying 10P Connector Terminals And Actuator
    G05487897Courtesy of AMERICAN HONDA MOTOR CO., INC.
  3. Check for continuity between the terminals. There should be continuity between the No. 8 [No. 7] and No. 10 [No. 5] terminals when the door lock knob switch in the UNLOCK position and no continuity when the switch is in the LOCK position.

    [ ] : Left rear door

  4. If the continuity is not specified, replace the door lock actuator.
scientia non olet · About LEMON Manuals