Start-up procedure and Diagnosis Menu
WARNING: This page is about a different car, the 2008 Acura TSX, 2007 Acura TSX, and 2006 Acura TSX. However, it is still accessible from the selected car via links, so may be relevant.
There are two ways to enter the diagnostic mode:
- Connect the SCS service connector (see FORCED STARTING OF DISPLAY
) to the navigation service connector located in the trunk. Turn the ignition switch to the ON (II) position. The display will go directly to the diagnostic menu screen.NOTE: When finished troubleshooting, make sure to remove the SCS service connector.
- Turn the ignition switch ON (II). Use the navigation display hard buttons, press and hold the 3 buttons (Menu, Map/Guide, and Cancel), and keep them pressed for about 5 seconds. The display screen will go directly to the "Select Diagnosis Items".NOTE: This only allows access to the diagnostic screens 3. All other navigation functions are disabled.
- After the display changes to the Select Diagnosis Items menu, select the item you want to check and the diagnostic will start. To return to the previous screen, select "RETURN".
- Navi System (Link)
- Monitor Check
- Unit Check
- Car Status
- F-CAN
- GPS Information
- Yaw Rate
- Tire Calibrate
- Functional Setup
- Version