Engine Oil Filter Replacement

Special Tools Required 

Oil filter wrench 07AAA-PLCA100

1. Remove the oil filter with the oil filter wrench.
2. Inspect the threads (A) and the rubber seal (B) on the new filter. Clean the seat on the engine block, then apply a light coat of oil to the new filter rubber seal. Use only filters with a built-in bypass system.
   Fig 1: Identifying Oil Filter Rubber Seal And Threads

   Courtesy of AMERICAN HONDA MOTOR CO., INC.
3. Install the oil filter by hand.
4. After the rubber seal seats, tighten the oil filter clockwise with the oil filter wrench (A).

   Tighten: 3/4 Turn Clockwise 

   Tightening Torque: 12 N.m (1.2 kgf.m, 8.8 lbf.ft) 

   Fig 2: Tightening Oil Filter W/Torque Specification

   Courtesy of AMERICAN HONDA MOTOR CO., INC.
5. If four numbers or triangle marks (1 to 4 or triangle marks) are printed around the outside of the filter, use the following procedure to tighten the filter.
   • Spin the filter on until its seal lightly seats against the block, and note which number or mark is at the bottom.
   • Tighten the filter by turning it clockwise three numbers or marks from the one you noted. For example, if number 2 is at the bottom when the seal is seated, tighten the filter until the number 1 comes around the bottom.
     Fig 3: Identifying Oil Filter Bolt

     Courtesy of AMERICAN HONDA MOTOR CO., INC.
     Fig 4: Identifying Tightening Procedure Chart

     
6. After installation, fill the engine with oil up to the specified level, run the engine for more than 3 minutes, then check for oil leakage.