LEMON Manuals: Even more car manuals for everyone
Home >> Acura >> 2004 >> MDX Base >> Repair and Diagnosis (Single Page) >> Heating, Ventilation & A/C (HVAC) >> HVAC Control Systems >> Climate Control System >> Recirculation Control Motor Replacement

Recirculation Control Motor Replacement

  1. Remove the glove box (see GLOVE BOX REMOVAL/INSTALLATION ).
  2. Disconnect the wire harness connectors.
    Fig 1: Disconnecting Wire Harness Connectors
    G03641897Courtesy of AMERICAN HONDA MOTOR CO., INC.
  3. Disconnect the 7P connector (A) from the recirculation control motor (B). Remove the self-tapping screws and the recirculation control motor from the blower unit.
    Fig 2: Removing Self-Tapping Screws And Recirculation Control Motor From Blower Unit
    G03641898Courtesy of AMERICAN HONDA MOTOR CO., INC.
  4. Install the motor in the reverse order of removal. Make sure the pin on the motor is properly engaged with the linkage. After installation, make sure the motor runs smoothly.
scientia non olet · About LEMON Manuals