LEMON Manuals: Even more car manuals for everyone
Home >> Acura >> 2003 >> MDX Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 99 (VSA (Vehicle Stability Assist) System) >> Wheel Speed Sensor Replacement >> Rear

Wheel Speed Sensor Replacement: Rear

WARNING: This page is about a different car, the 2009 Acura MDX, 2008 Acura MDX, and 2007 Acura MDX. However, it is still accessible from the selected car via links, so may be relevant.
  1. Turn the ignition switch to LOCK (0).
  2. Disconnect the wheel speed sensor connector (A).
    Fig 1: Wheel Speed Sensor And Wheel Speed Sensor Connector With Torque Specification
    G05486919Courtesy of AMERICAN HONDA MOTOR CO., INC.
  3. Remove the clips, the bolt, and the wheel speed sensor (B).
  4. Install the wheel speed sensor in the reverse order of removal, and note these items:
    • Install the sensor carefully to avoid twisting the wires.
    • If the wheel speed sensor comes in contact with the hub bearing unit, it is faulty.
  5. Start the engine, and check that the ABS, the VSA indicators, and the trailer stability assist warning goes off.
  6. Test-drive the vehicle, and check that the ABS, the VSA indicators, and the trailer stability assist warning do not come on.
scientia non olet · About LEMON Manuals