Suspension Stroke Sensor Replacement

WARNING: This page is about a different car, the 2009 Acura MDX, 2008 Acura MDX, and 2007 Acura MDX. However, it is still accessible from the selected car via links, so may be relevant.

NOTE:

Right side of suspension stroke sensor for active damper system is the same procedure as left side suspension stroke sensor.
After install the rear suspension stroke sensor, do the memorizing rear suspension full rebound position (see MEMORIZING REAR SUSPENSION FULL REBOUND POSITION ).

Raise the vehicle, make sure it is securely supported.
Disconnect the 3P connector (A) from the suspension stroke sensor (B).
LEFT-FRONT

Fig 1: Left And Front Suspension Stroke Sensor From 3P Connector With Torque Specification
Courtesy of AMERICAN HONDA MOTOR CO., INC.

LEFT-REAR

Fig 2: Left And Rear Suspension Stroke Sensor From 3P Connector With Torque Specification
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Remove the bolt and nut, then remove the suspension stroke sensor.
Install the sensor in the reverse order of removal.
After installing, do the headlight initial position learning procedure (see HEADLIGHT INITIAL POSITION LEARNING PROCEDURE ).