LEMON Manuals: Even more car manuals for everyone
Home >> Acura >> 2003 >> MDX Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 44 (SRS (Supplemental Restraint System)) >> Side Impact Sensor (First) Replacement >> Installation

Side Impact Sensor (First) Replacement: Installation

WARNING: This page is about a different car, the 2009 Acura MDX, 2008 Acura MDX, and 2007 Acura MDX. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the new side impact sensor (first) with the TORX bolt (A), then connect the floor wire harness 2P connector (B) to the side impact sensor (first).
    Fig 1: TORX Bolt And Floor Wire Harness 2P Connector With Torque Specification
    G05489026Courtesy of AMERICAN HONDA MOTOR CO., INC.
  2. Reconnect the negative cable to the battery.
  3. After installing the side impact sensor (first) confirm proper system operation: Turn the ignition switch ON (II); the SRS indicator should come on for about 6 seconds and then go off.
  4. Reinstall all removed parts.
scientia non olet · About LEMON Manuals