LEMON Manuals: Even more car manuals for everyone
Home >> Acura >> 2003 >> MDX Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 44 (SRS (Supplemental Restraint System)) >> SRS Unit Replacement >> Installation

SRS Unit Replacement: Installation

WARNING: This page is about a different car, the 2009 Acura MDX, 2008 Acura MDX, and 2007 Acura MDX. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the new SRS unit (A) with new TORX bolts (B), then connect the connectors (C) to the SRS unit; push them into position until they click.
    NOTE: Be sure the SRS unit is sitting squarely against it's bracket before torquing the TORX bolt.
    Fig 1: SRS Unit, Torx Bolts And Connectors With Torque Specification
    G05489024Courtesy of AMERICAN HONDA MOTOR CO., INC.
  2. Reconnect both seat belt tensioner connectors (see step  8 ).
  3. Reconnect the negative cable to the battery.
  4. Calibrate the ODS unit (see ODS UNIT CALIBRATION  ).
  5. Do the ODS unit operation check (see ODS UNIT OPERATION CHECK  ).
  6. After installing the SRS unit, confirm proper system operation: Turn the ignition switch ON (II); the SRS indicator should come on for about 6 seconds and then go off.
  7. Reinstall all removed parts.
scientia non olet · About LEMON Manuals