Roll Rate Sensor Replacement: Installation

WARNING: This page is about a different car, the 2009 Acura MDX, 2008 Acura MDX, and 2007 Acura MDX. However, it is still accessible from the selected car via links, so may be relevant.

Install the new roll rate sensor with the TORX bolts (A) then connect the floor wire harness 2P connector (B) to the roll rate sensor (C).

Fig 1: Floor Wire Harness 2P Connector With Torque Specification
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Reconnect the negative cable to the battery.
Reinstall all removed parts.
After installing the roll rate sensor, confirm proper system operation: Turn the ignition switch to ON (II); the SRS indicator should come on for about 6 seconds and then go off.