LEMON Manuals: Even more car manuals for everyone
Home >> Acura >> 2003 >> MDX Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 44 (SRS (Supplemental Restraint System)) >> Rear Safing Sensor Replacement >> Installation

Rear Safing Sensor Replacement: Installation

WARNING: This page is about a different car, the 2009 Acura MDX, 2008 Acura MDX, and 2007 Acura MDX. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the new rear safing sensor with the TORX bolt (A) then connect the floor wire harness 4P connector (B) to the rear safing sensor (C).
    Fig 1: Floor Wire Harness 4P Connector With Torque Specification
    G05489032Courtesy of AMERICAN HONDA MOTOR CO., INC.
  2. Reconnect the negative cable to the battery.
  3. After installing the rear safing sensor, confirm proper system operation: Turn the ignition switch ON (II): the SRS indicator should come on for about 6 seconds and then go off.
  4. Install all removed parts.
scientia non olet · About LEMON Manuals