LEMON Manuals: Even more car manuals for everyone
Home >> Acura >> 2003 >> MDX Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 44 (SRS (Supplemental Restraint System)) >> Front Impact Sensor Replacement >> Installation

Front Impact Sensor Replacement: Installation

WARNING: This page is about a different car, the 2009 Acura MDX, 2008 Acura MDX, and 2007 Acura MDX. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the new front impact sensor with a new TORX bolts (A), then connect the left or right engine compartment wire harness 2P connector (B) to the front impact sensor (C).
    Fig 1: Engine Compartment Wire Harness 2P Connector, TORX Bolts And Front Impact Sensor With Torque Specification
    G05489038Courtesy of AMERICAN HONDA MOTOR CO., INC.
  2. Reconnect the negative cable to the battery.
  3. After installing the front impact sensor, confirm proper system operation: Turn the ignition switch ON (II); the SRS indicator should come on for about 6 seconds and then go off.
  4. Reinstall all removed parts.
scientia non olet · About LEMON Manuals