LEMON Manuals: Even more car manuals for everyone
Home >> Acura >> 2003 >> MDX Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 44 (SRS (Supplemental Restraint System)) >> Driver's Seat Position Sensor Replacement >> Installation

Driver's Seat Position Sensor Replacement: Installation

WARNING: This page is about a different car, the 2009 Acura MDX, 2008 Acura MDX, and 2007 Acura MDX. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
  • Be sure to install the harness so it does not pinched or interfere with other parts.
  • Do not turn the ignition switch ON (II), and do not connect the battery cable while installing the driver's seat position sensor.
  • After installing the driver's seat position sensor, make sure it is clean. Keep it away from dust.
  1. Install the new driver's seat position sensor with a TORX bolt (A), then connect the driver's seat wire harness 2P connector to the driver's seat position sensor (B).
    Fig 1: Driver's Seat Wire Harness 2P Connector With Torque Specification
    G05489040Courtesy of AMERICAN HONDA MOTOR CO., INC.
  2. Reconnect the driver's airbag 4P connector (see step  2 ).
  3. Install the driver's seat assembly (see FRONT SEAT REMOVAL/INSTALLATION ).
  4. Reconnect the negative cable to the battery.
  5. Check the operation of the driver's seat position sensor with the HDS (see DRIVER'S SEAT POSITION SENSOR OPERATION CHECK  ).
scientia non olet · About LEMON Manuals