Active Damper Control Unit Inputs and Outputs for Connector B (14P)

WARNING: This page is about a different car, the 2009 Acura MDX, 2008 Acura MDX, and 2007 Acura MDX. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Active Damper Control Unit Connector B (14P)

Courtesy of AMERICAN HONDA MOTOR CO., INC.

ACTIVE DAMPER CONTROL UNIT CONNECTOR TERMINAL REFERENCE B (14P)

Terminal number	Wire color	Terminal sign	Description	Signal
Terminal number	Wire color	Terminal sign	Description	Terminals	Conditions	Voltage
1	WHT	CAN H	CAN communication circuit	-	-	-
3	LT BLU	K-LINE	Communication with HDS	3-GND	HDS not connected	About 5 V
4	PNK	SVCC	Supply power to. the sensors	4-GND	Ignition switch ON (II)	About 5 V
6	PNK	HVCC	Supply power to the sensor and the other unit	6-GND	Ignition switch ON (II)	About 5 V
7	LT BLU	RLST	Detects left-rear stroke sensor signal	7-GND	Damper stroking	About 0-5 V
8	RED	CANL	CAN communication circuit	-	-	-
10	LT GRN	RLG	Detects left-rear acceleration sensor signal	10-GND	Move the vehicle up and down	About 0-5 V
11	GRY	SG	Ground for the sensors	11-GND	At all times	0.1 V or less
12	BRN	RRG	Detects right-rear acceleration sensor signal	12-GND	Move the vehicle up and down	About 0-5 V
14	YEL	FCG	Detects front acceleration sensor signal	14-GND	Move the vehicle up and down	About 0-5 V