Hood Latch Replacement

NOTE:

Remove the bolts securing the hood latch (A) on the body.

Fig 1: Removing Hood Latch Bolts
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Detach the hood opener cable (B) from the latch, then remove the latch from the body.
Disconnect the hood opener cable (A) from the hood latch (B), and disconnect the hood latch switch connector (C), and detach the harness clip (D). Take care not to kink the cable.

Fig 2: Disconnecting Hood Opener Cable From Hood Latch
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Install the hood latch in the reverse order of removal, and note these items:
- Apply multipurpose grease to each location of the hood latch as indicated by the arrows shown in Fig 3 .
- Make sure the hood opener cable is connected properly and hood latch switch connector is plugged in properly.
- Make sure the cable actuates the latch before you close the hood.
- Adjust the hood latch alignment (see ADJUSTMENT ).
- Make sure the hood locks securely.
  
  Fig 3: Applying Multipurpose Grease To Each Location Of Hood Latch
  Courtesy of AMERICAN HONDA MOTOR CO., INC.