Trip Meter Select/Reset Switch
WARNING: This page is about a different car, the 2003 Acura 3.2TL and 2002 Acura 3.2TL. However, it is still accessible from the selected car via links, so may be relevant.
Remove instrument cluster assembly. See INSTRUMENT CLUSTER under REMOVAL & INSTALLATION. Disconnect trip meter select/reset switch 5-pin connector. Check for continuity between specified switch terminals with switch in each specified position. See TRIP METER SELECT/RESET SWITCH CONTINUITY table. If continuity is not as specified, replace trip meter select/reset switch.
TRIP METER SELECT/RESET SWITCH CONTINUITY
| Trip Meter Select/Reset Switch Position | (1) Check Continuity Between Terminals No. | ||
|---|---|---|---|
| Select (ON) | 1 & 2; 4 & 5 | ||
| Reset (ON) | 2 & 3 | ||
|
|||