Driver's Power Seat Motor Test
WARNING: This page is about a different car, the 2003 Acura 3.2CL and 2002 Acura 3.2CL. However, it is still accessible from the selected car via links, so may be relevant.
Remove driver's seat. See FRONT SEATS under REMOVAL & INSTALLATION. Using fused jumper wires, apply battery voltage and ground to specified motor harness connector terminals. See DRIVER'S POWER SEAT MOTOR TEST table. See Fig 1 . If any motor fails any portion of test, replace faulty motor.
DRIVER'S POWER SEAT MOTOR TEST
| Application | (1) Connect Battery To Terminals (+) & (-) | |||
|---|---|---|---|---|
| Slide Motor | ||||
| Forward | 1 & 2 | |||
| Backward | 2 & 1 | |||
| Front Up-Down Motor | ||||
| Up | 2 & 3 | |||
| Down | 3 & 2 | |||
| Rear Up-Down Motor | ||||
| Up | 3 & 4 | |||
| Down | 4 & 3 | |||
| Recline Motor | ||||
| Forward | 2 & 1 | |||
| Backward | 1 & 2 | |||
|
||||