Test Equipment

WARNING: This page is about a different car, the 2004 Acura 3.5RL, 2003 Acura 3.5RL, 2002 Acura 3.5RL, and 2001 Acura 3.5RL. However, it is still accessible from the selected car via links, so may be relevant.

All voltage tests should be performed by backprobing with a Digital Volt-Ohmmeter (DVOM) with a minimum 10-megohm input impedance, unless specifically stated differently in testing procedure. DO NOT use a test light or analog meter to check circuits with solid-state devices. Solid-state devices can be damaged. Ensure all jumper wires include a 5-amp, in-line fuse.

Use 2 Backprobe Sets (07SAZ-001000A) to backprobe Powertrain Control Module (PCM) when directed by testing. See Fig 1 . For PCM connector terminal identification, see CONNECTOR IDENTIFICATION . DO NOT puncture wire insulation. Place tester probe into contact with terminal, from terminal side of wiring harness connectors in engine compartment. For female connectors, touch terminal lightly with tester probe. DO NOT insert probe into terminal.

Fig 1: Using Backprobe Set (Typical)

Courtesy of AMERICAN HONDA MOTOR CO., INC.