LEMON Manuals: Even more car manuals for everyone
Home >> Acura >> 2001 >> 3.2CL Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 17 (Engine Performance System Self-Diagnostics) >> Diagnostic Tests >> DTC P0116: Engine Coolant Temperature (ECT) Sensor Circuit Range/Performance Problem (2004 3.5RL) >> Diagnostic Procedure

Diagnostic Procedure

WARNING: This page is about a different car, the 2004 Acura 3.5RL, 2003 Acura 3.5RL, 2002 Acura 3.5RL, and 2001 Acura 3.5RL. However, it is still accessible from the selected car via links, so may be relevant.
  1. Turn ignition switch off. Using HDS (Honda Diagnostic System) or scan tool, check ECT output temperature or voltage. If ECT output temperature is about 176°F (80°C) or higher, or 0.86 volt or less, go to next step. If ECT output temperature is not about 176°F (80°C) or higher, or not 0.86 volt or less, go to step  3 .
  2. Note current coolant temperature. Turn ignition switch off. Cool engine for one hour, and recheck ECT output temperature or voltage with scan tool or HDS. If ECT changes 3.6°F (2°C) or more, problem is intermittent. System is okay at this time. Check thermostat and cooling system. Repair as necessary. If ECT does not change 3.6°F (2°C) or more, replace ECT sensor.
  3. Note current coolant temperature. Start engine. Hold engine speed at 3000 RPM with no load and transmission in Park or Neutral until radiator fan comes on, then allow engine to idle. Check ECT output temperature or voltage with scan tool or HDS. If ECT changes 3.6°F (2°C) or more, problem is intermittent. System is okay at this time. Check thermostat and cooling system. Repair as necessary. If ECT does not change 3.6°F (2°C) or more, replace ECT sensor.
scientia non olet · About LEMON Manuals