LEMON Manuals: Even more car manuals for everyone
Home >> Acura >> 2001 >> 3.2CL Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 1 (3.5L V6) >> Removal & Installation >> TDC Sensor >> Removal & Installation

Removal & Installation

WARNING: This page is about a different car, the 2002 Acura MDX and 2001 Acura MDX. However, it is still accessible from the selected car via links, so may be relevant.
  1. Set No. 1 piston to TDC position (White mark on crankshaft aligns with pointer, and rear camshaft pulley mark and upper cover mark are aligned).
  2. Remove upper timing belt covers. Grind end of a battery hold-down bolt to a slight bevel. Install and hand-tighten bolt to hold belt tension adjuster position.
  3. Remove front camshaft pulley. Remove timing belt from front of camshaft pulley.
  4. Disconnect TDC 1/TDC 2 sensor connector, then remove back cover. Remove sensor from back cover.
  5. To install, reverse removal procedure.
scientia non olet · About LEMON Manuals