Intermittent Wiper Relay
- Turn ignition switch to OFF position. Remove intermittent wiper relay. See COMPONENT LOCATIONS
.
- Using DVOM, ensure continuity exists between relay terminals No. 3 and 6, and terminals No. 2 and 4. See Fig 1
. Continuity should not exist between terminals No. 1 and 2.
- Using fused jumper wires, apply battery voltage and ground between relay coil terminals No. 3 and 6. Continuity should now exist between terminals No. 1 and 2. Ensure continuity does not exist between terminals No. 2 and 4. Replace relay if continuity is not as specified.
Courtesy of AMERICAN HONDA MOTOR CO., INC.