LEMON Manuals: Even more car manuals for everyone
Home >> Acura >> 2000 >> Integra GS-R, 4D Sedan >> Repair and Diagnosis >> External Pages >> Different car >> Section 21 (Computer Relearn Procedures) >> MAZDA >> Programming Pcm (B2500, B3000, B4000 & 626) >> Flash Vehicle Identification (VID) Block Procedure

Flash Vehicle Identification (VID) Block Procedure

WARNING: This page does not describe the selected car, but rather 126 other vehicles, including the 1999 Volvo V70, 1999 Volvo S80, 1999 Volvo S70, 1999 Volvo C70, and 1999 Volkswagen Passat. However, it is still accessible from the selected car via links, so may be relevant.
  1. To perform this procedure NGS tester, Ford Service Function (FSF) card and NGS Flash Cable (007-00531) must be used. Plug flash cable into scan tool. Plug other end of flash cable into Data Link Connector (DLC). From the scan tool main menu, select SERVICE BAY FUNCTIONS, PCM-POWERTRAIN CONTROL MODULE and then PROGRAMMABLE MODULE INSTALLATION.
  2. The NGS tester display should show 2 selections. The first is selection is for the old PCM information to be retrieved and stored. The second selection is for restoring the new PCM with information that has been retrieved from the old PCM. Follow display instructions or refer to instruction sheet included with FSF card. If Vehicle Identification (VID) block has been reprogrammed previously, NGS tester will display a message indicating the need to reflash entire Integrated Circuit (IC). This procedure can only be performed using Ford's Service Bay Technical System (SBTS).
scientia non olet · About LEMON Manuals