LEMON Manuals: Even more car manuals for everyone
Home >> Acura >> 2000 >> Integra GS-R, 2D Coupe >> Repair and Diagnosis >> Engine Performance >> Engine Controls - On-Vehicle Adjustments >> Idle Speed & Mixture >> Idle Speed >> 3.2TL

Idle Speed: 3.2TL

  1. Disconnect EVAP purge control solenoid valve 2-pin connector. DO NOT disconnect Idle Air Control (IAC) valve connector. Connect a tachometer. See Figure-Figure . Start engine and run at 3000 RPM, with no loads and transmission in Park or Neutral, until radiator fan comes on. Allow engine to idle.
  2. Turn off all electrical loads and check idle speed. See IDLE SPEED SPECIFICATIONS  table. If necessary, turn idle adjusting screw to correct idle. Recheck idle speed after each 1/4-turn of idle adjusting screw.
  3. Turn blower motor switch to high and A/C on, then let engine idle for one minute. Recheck idle speed. If necessary, turn idle adjusting screw to correct idle. DO NOT turn idle adjusting screw when A/C is on. Recheck idle speed after each 1/4 turn of idle adjusting screw. If idle speed is not as specified, go to TROUBLE SHOOTING - NO CODES article. Reconnect EVAP purge control solenoid valve 2-pin connector.
scientia non olet · About LEMON Manuals