Removal & Installation: Engine: Installation

1. To install, reverse removal procedure. Install transmission mount bracket, and tighten bolts. Install transmission mount, DO NOT tighten. Tighten center nut on right engine mount bracket and install vacuum hose. See TORQUE SPECIFICATIONS . Tighten center nut on left engine mount bracket, and install vacuum hose.
2. Install transmission beam and tighten bolts in sequence. See Fig 1. Tighten left front mount bolt. See TORQUE SPECIFICATIONS . Tighten right front mount bolt.
3. When installing axle shafts, use NEW spring clips. Insert each axle shaft until spring clip clicks into groove of differential side gear. Ensure all wire harness connectors and hoses are connected properly.
4. Check throttle cable adjustment. See THROTTLE CABLE ADJUSTMENT  under ADJUSTMENTS. Adjust transmission shift link. See SHIFT LINK ADJUSTMENT (A/T)  under ADJUSTMENTS. Adjust accessory drive belt tension. Fill all fluids to proper level. Bleed air from cooling system. See BLEEDING COOLING SYSTEM . Check for fluid leaks.

Fig 1: Transmission Beam Tightening Sequence

Courtesy of AMERICAN HONDA MOTOR CO., INC.