LEMON Manuals: Even more car manuals for everyone
Home >> Acura >> 2000 >> 1.6EL XS, Automatic >> Repair and Diagnosis >> Engine Performance >> Tune-Up >> Ignition System >> Ignition Wire Inspection and Test

Ignition Wire Inspection and Test

CAUTION: Carefully remove the ignition wires by pulling on the rubber boots. Do not bend the wires; you might break them inside.
  1. Check the condition of the ignition wire terminals. If any terminal is corroded, clean it, and if it is broken or distorted, replace the ignition wire.
    Fig 1: Checking Condition Of Ignition Wire Terminals
    G06289323
  2. Connect ohmmeter probes and measure resistance.

    Ignition Wire Resistance: 

    25 kΩ max. at 68°F (20°C) 

    Fig 2: Connecting Ohmmeter Probes And Measure Resistance
    G06289324
  3. If resistance exceeds 25 kΩ, replace the ignition wire.
scientia non olet · About LEMON Manuals