Shift Lock Solenoid Test

Remove the front console (see CONSOLES AND BEVERAGE HOLDER REMOVAL/INSTALLATION ).
Disconnect the shift lock solenoid 2P connector.

Fig 1: Identifying Shift Lock Solenoid And 2P Connector
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Connect battery power to the No. 1 terminal, and to the No. 2 terminal of the solenoid, momentarily.
NOTE:
- Do not connect power to the No. 2 (-) terminal (reverse polarity), or you will damage the diode inside the solenoid.
- Make sure there is clearance between the stop pin and the base bracket when the solenoid switches ON and OFF.
  
  Fig 2: Identifying Clearance Between Stop Pin And Base Bracket
  Courtesy of AMERICAN HONDA MOTOR CO., INC.
Check that the shift lock releases when the release lever is pushed, and check that it locks when the release lever is released.
If the solenoid does not work, replace it.