Trunk Trim Removal/Installation

WARNING: This page is about a different car, the 1997 Acura 1.6EL. However, it is still accessible from the selected car via links, so may be relevant.

CAUTION:

Wear gloves to remove and install the trim and panels.
When prying with a flat tip screwdriver, wrap it with protective tape to prevent damage.

NOTE:

Take care not to bend or scratch the trim and panels.
When removing the trunk side trim or trunk trim panel, fold the seat-back forward.

Fig 1: Identifying Trunk Trim Panel, Rear Trim Panel And Spare Tire Lid
Courtesy of AMERICAN HONDA MOTOR CO., INC.

Installation is the reverse of the removal procedure.

NOTE:

If necessary, replace any damaged clips.
To install the A clips, pull the inner clip up, install the clip, then push the inner clip until it's flush.