Bleeding Procedures
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 1998 Acura 3.5RL, 1998 Acura 3.2TL, 1998 Acura 2.5TL, 1997 Acura 3.5RL, and 1997 Acura 3.2TL. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
Use only clean DOT 3 or 4 brake fluid. Ensure no dirt or other foreign matter contaminates brake fluid. DO NOT mix different brands of brake fluid, as they may not be compatible. Avoid spilling brake fluid on car, as it will damage paint. If brake fluid contacts paint, immediately flush with water.
- Ensure master cylinder reservoir is full before performing bleeding procedure. Refill reservoir after bleeding each wheel. Have an assistant slowly pump brake pedal several times, then apply steady pressure. Loosen brake bleed screw at each wheel to allow air to escape from system. Tighten bleed screw to 78 INCH lbs. (8.8 N.m). Repeat procedure until air bubbles no longer appear in fluid.
- On 2.5TL and 3.2TL, bleed brakes in following sequence: left front, right front, right rear, left rear. On 3.5RL, bleed brakes in following sequence: right rear, left front, left rear, right front. On all models, ensure master cylinder reservoir is full. Road test vehicle and check brake performance.