Removal & Installation: Engine: Installation

WARNING: This page is about a different car, the 1999 Acura 3.0CL. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: Perform the following installation procedure in specified order to eliminate excessive noise and vibration, and to prevent reduction in bushing life.

To install, reverse removal procedure. Tighten nut on rear mount bracket. See TORQUE SPECIFICATIONS . Tighten nut on front mount bracket. Install engine side mount, and tighten bolts to engine to specification. DO NOT tighten mount to frame bolt. See Fig 1.
Install transmission mount and tighten nuts to transmission to specification. DO NOT tighten mount-to-frame bolt. Tighten mount-to-frame bolt on engine side mount. Tighten mount-to-frame bolt on transmission mount.
When installing axle shafts, use NEW spring clips. Insert each axle shaft until spring clip clicks into groove of differential side gear. Ensure all wire harness connectors and hoses are connected properly.
Check throttle cable adjustment. See THROTTLE CABLE ADJUSTMENT under ADJUSTMENTS. Adjust transmission shift cable. See SHIFT CABLE ADJUSTMENT (A/T) under ADJUSTMENTS. Fill all fluids to proper level. Bleed air from cooling system. See BLEEDING COOLING SYSTEM . Check for fluid leaks.

Fig 1: Exploded View Of Engine Mounts

Courtesy of AMERICAN HONDA MOTOR CO., INC.