Driver's Position Memory Switch Test

WARNING: This page is about a different car, the 1995 Acura Legend. However, it is still accessible from the selected car via links, so may be relevant.

Remove driver's door panel. See DRIVER'S DOOR PANEL under REMOVAL & INSTALLATION. Disconnect driver's position memory switch 10-pin connector. Remove switch from door panel. Using an ohmmeter, verify continuity is as specified in DRIVER'S POSITION MEMORY SWITCH CONTINUITY table. See Fig 1 . If continuity is not as specified, replace faulty switch.

DRIVER'S POSITION MEMORY SWITCH CONTINUITY

Switch Position

Terminals

MEMO Button

E & J

Off

No Continuity

Position Button 1

G & J

Off

No Continuity

Position Button 2

F & J

Off

No Continuity

Indicator 1

A & C ⁽¹⁾

Indicator 2

A & D ⁽¹⁾

Illumination

No Continuity

⁽¹⁾	Indicators 1 and 2 are LEDs. When checking continuity place ohmmeter negative probe at connector terminal "C"

Fig 1: Identifying Driver's Position Memory Switch Terminals

Courtesy of AMERICAN HONDA MOTOR CO., INC.