A/T Gear Position Switch
NOTE:
The A/T gear position switch also contains back-up light switch and neutral position switch. Back-up light and neutral position switch can also be checked when checking A/T gear position switch.
- The A/T gear position switch is mounted on side of transaxle. See Figure -Figure . Raise and support vehicle. Remove splash shield located below transaxle.
- Disconnect 14-pin connector from A/T gear position switch and note terminal identification. See Fig 1
. Using ohmmeter, check continuity between specified terminals or body ground in relation to shift lever position. See A/T GEAR POSITION SWITCH CONTINUITY SPECIFICATIONS
.NOTE: Check continuity while moving shift lever back and forth in free play area of each gear position. DO NOT touch push button on shift lever when checking continuity.
- If continuity is not as specified, A/T gear position switch may require adjustment. See A/T GEAR POSITION SWITCH under REMOVAL & INSTALLATION. If correct continuity cannot be obtained by adjusting A/T gear position switch, replace A/T gear position switch.
A/T GEAR POSITION SWITCH CONTINUITY SPECIFICATIONS
| Shift Lever Position | Terminal Number | |
|---|---|---|
| A/T Gear Position Switch | ||
| "P" | 2 & Body Ground | |
| "R" | 4 & Body Ground | |
| "N" | 5 & Body Ground | |
| "D4" | 11, 6 & Body Ground | |
| "D" | 11, 7 & Body Ground | |
| "2" | 11, 8 & Body Ground | |
| "1" | 9 & Body Ground | |
| Back-Up Light Switch | ||
| "R" | 12 & 14 | |
| Neutral Position Switch | ||
| "P" & "N" | 10 & Body Ground | |