A/T Gear Position Switch
NOTE:
The A/T gear position switch also contains back-up light switch and neutral position switch. Back-up light and neutral position switch can also be checked when checking A/T gear position switch.
- The A/T gear position switch is mounted on driver's side of shift lever. See Figure . Remove console.
- Disconnect 14-pin electrical connector from A/T gear position switch and note terminal identification. See Fig 1
. Using ohmmeter, check continuity between specified terminals in relation to shift lever position. See A/T GEAR POSITION SWITCH CONTINUITY SPECIFICATIONS
table.NOTE: Check continuity while moving shift lever back and forth in free play area of each gear position. DO NOT touch push button on shift lever when checking continuity.
- If continuity is not as specified, A/T gear position switch may require adjustment. See A/T GEAR POSITION SWITCH under REMOVAL & INSTALLATION. If correct continuity cannot be obtained by adjusting A/T gear position switch, replace A/T gear position switch.
A/T GEAR POSITION SWITCH CONTINUITY SPECIFICATIONS
| Shift Lever Position | Terminal No. | |
|---|---|---|
| A/T Gear Position Switch | ||
| "P" | 9 & 12 | |
| "R" | 8 & 9 | |
| "N" | 7 & 9 | |
| "D4" | 1, 5 & 9 | |
| "D" | 2, 5 & 9 | |
| "2" | 3, 5 & 9 | |
| "1" | 4 & 9 | |
| Back-Up Light Switch | ||
| "R" | 10 & 11 | |
| Neutral Position Switch | ||
| "P" & "N" | 6 & 14 | |