LEMON Manuals: Even more car manuals for everyone
Home >> Acura >> 1993 >> Integra GS-R >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (1.8L 4-CYL) >> Overhaul >> Cylinder Block

Cylinder Block

WARNING: This page is about a different variant/trim than selected.
  1. Measure cylinder bore out-of-round and taper. If either out-of-round or taper exceeds 0.002" (0.05 mm), rebore cylinder for oversize pistons. If any cylinder exceeds oversize bore service limit, replace cylinder block. See CYLINDER BLOCK table under ENGINE SPECIFICATIONS at end of article.
  2. Service limit is 0.004" (0.10 mm). If cylinder bore is okay, hone cylinder to obtain a 60-degree crosshatch pattern. After honing, wash cylinder bore with hot soapy water. Air-dry cylinder bore, and apply engine oil to prevent rusting. Using a feeler gauge and straightedge, measure cylinder block deck surface warpage.
scientia non olet · About LEMON Manuals