Right Mirror Inoperative

Connect the YEL/BLK terminal of the 10-pin connector to the BLU/BLK terminal and the BLU/WHT (or BLU/GRN) terminal to body ground with jumper wires. See Figure . The right mirror should tilt down (or swing left) when the ignition switch is turned ON.

• If the mirror does not tilt down (or does not swing left), remove the right door panel and check for a break in the BLU/WHT (or BLU/GRN) wire between the right door mirror and the switch. If the wire is okay, check the right door mirror motor.
• If the mirror neither tilts down nor swings left, repair the BLU/BLK wire.
• If the mirror operates properly, check the mirror switch.