Retrieving Codes
- Turn engine off. Turn ignition on. Ensure ANTI-LOCK warning light comes on. Start engine and check ANTI-LOCK warning light. If warning light goes out, there are no fault codes.
- If warning light stays on, turn engine off. Turn ignition on , DO NOT start engine. Record LED blinking sequence on the control unit. See Fig 1
.
- First number of code indicates main code. Second number indicates sub code. There should be an approximate 10 second delay before LED will start blinking after ignition is turned on. A total of 3 codes can be set at one time. To recheck sequence, turn ignition off for few seconds; then turn ignition back on.
Courtesy of AMERICAN HONDA MOTOR CO., INC.