Checking The Vacuum Pump: Verification

HINT: After carrying out the repair, check that the fault has been remedied. 

• Ignition off.
• Before carrying out the next corrective action - wait approximately 3 minutes after switching the ignition off (system relay disconnected).

  Pump the brake pedal a few times so that all negative pressure in the power brake booster disappears.

  Check the vacuum pump's function by depressing the brake pedal with the ignition on. The vacuum pump must start and run for a few seconds to build up a new vacuum and then stop.

Is the function OK? 

• YES 

  Refer to VERIFICATION 

• NO 

  Refer to INFORMATION