Checking the wiring: Notes
- Ignition off
- The control module for the steering wheel angle sensor disconnected
- Steering wheel module disconnected
- Connect the breakout box to the control module for the steering wheel angle sensor and to the steering wheel module.
Check the wiring between the control module for the steering wheel angle sensor terminal #2 (#A26) and steering wheel module terminal #6 (#A6). Check for a short-circuit to supply voltage according to Short-circuit to supply voltage, permanent faults .
Try replacing the steering wheel angle sensor if no fault is found in the wiring.
Other information:
- To disconnect the control module for the steering wheel angle sensor, see Steering wheel module (SWM), replacing
- To connect the breakout box to the steering wheel module, see Steering wheel module (SWM), replacing
- To connect the breakout box to the control module for the steering wheel angle sensor, see Connecting the breakout box to the steering angle sensor
- To disconnect and replace the steering wheel angle sensor, see Contact reel / steering wheel angle sensor, replacing .
- Continue
Refer to Verification