LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2013 >> Outback Base, Standard Trans >> Repair and Diagnosis >> Accessories & Equipment >> Entertainment Systems >> Entertainment System >> Steering Satellite Switch >> Removal

Steering Satellite Switch: Removal

  1. Position the front wheels straight ahead. (After moving a vehicle 5 m (16 ft) or more with front wheels positioned straight ahead, make sure that the vehicle moves straight ahead.)
  2. Turn the ignition switch to OFF.
  3. Disconnect the ground cable from battery and wait for at least 60 seconds before starting work.
  4. Remove the driver's airbag module assembly.
    CAUTION: Before handling the airbag module, refer to CAUTION .
    1. Using a hexagon wrench etc. wrapped by protective tape, insert the snap pins and release the locks (3 locations).
      Fig 1: Releasing Airbag System Locks Using Hexagon Wrench
      G08316326Courtesy of SUBARU OF AMERICA, INC.
    2. Disconnect the horn harness and airbag connector and remove the airbag module assembly. Refer to DRIVER' AIRBAG MODULE, CURTAIN AIRBAG MODULE, PRETENSIONER & LAP SEAT BELT PRETENSIONER .
      Fig 2: Disconnecting Horn Harness And Airbag Connector
      G08316327Courtesy of SUBARU OF AMERICA, INC.
  5. Remove the steering wheel.
    CAUTION:
    • Always use the steering wheel puller for removal to avoid deforming the steering wheel.
    • If the steering wheel has been removed, make sure that the roll connector is not turned from the original position.
    1. Disconnect the connector and remove the nut.
    2. Put alignment marks, and remove the steering wheel using a steering wheel puller.

      Preparation tool: 

      Steering wheel puller 

      Fig 3: Locating Steering Wheel Connector And Mounting Nut
      G08583669Courtesy of SUBARU OF AMERICA, INC.
  6. Remove the satellite switch.
    1. Remove the screw, disconnect the connector and remove the paddle shift switch. (Model with paddle shift)
      Fig 4: Locating Paddle Shift Switch Mounting Screws
      G08583670Courtesy of SUBARU OF AMERICA, INC.
    2. Remove the steering switch connector and screw. (luminescent meter model)
    3. Release the claws and clips, detach the cover - steering wheel LWR.
      Fig 5: Locating Steering Switch Connector And Screw
      G08583671Courtesy of SUBARU OF AMERICA, INC.
    4. Remove the screws and then remove the satellite switch assembly.
      Fig 6: Locating Satellite Switch Assembly Mounting Screws
      G08583672Courtesy of SUBARU OF AMERICA, INC.