LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2008 >> G8 Base >> Repair and Diagnosis >> Engine Performance >> System >> Engine Control System & Fuel System - 3.6L - Introduction (2 Of 2) >> Repair Instructions >> Crankshaft Position Sensor Replacement >> Removal Procedure

Removal Procedure

  1. Turn the ignition OFF.
    CAUTION: Refer to Vehicle Lifting Caution .
    CAUTION: Refer to Safety Glasses Caution .

    Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .

    2. Fig 1: Identifying CKP Electrical Connector
    GM1949783Courtesy of GENERAL MOTORS CORP.
  2. Reposition the wiring harness heat shield to obtain access.
  3. Disconnect the crankshaft position (CKP) harness connector (3) from the CKP.
    4. Fig 2: Identifying CKP Sensor To Engine Block Retaining Bolt
    GM1949785Courtesy of GENERAL MOTORS CORP.
  4. Remove the CKP to engine block retaining bolt (1) from the CKP sensor (2).
  5. Remove the CKP sensor (2) from the engine block.
scientia non olet · About LEMON Manuals