LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2004 >> Aztek Base, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 274 (Engine Controls (Introduction) - 3.8L) >> Repair Instructions >> Fuel Tank Pressure Sensor Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2004 Pontiac Grand Prix. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the negative battery cable. Refer to Battery Negative Cable Disconnect/Connect Procedure in Engine Electrical.
  2. Remove the rear compartment trim panel. Refer to Floor Trim Plate Replacement - Rear in Body Rear End.
  3. Remove the nuts from the fuel sender access panel.
    4. Fig 1: Fuel Sender Access Panel
    GM65739Courtesy of GENERAL MOTORS CORP.
  4. Remove the fuel sender access panel.
  5. Disconnect the fuel tank pressure sensor electrical connector.
    6. Fig 2: Fuel Pump & Sender Assembly Component View
    GM50636Courtesy of GENERAL MOTORS CORP.
  6. Remove the fuel tank pressure sensor (7) from the fuel sender assembly (1).
scientia non olet · About LEMON Manuals