Instrument Panel Speaker: Installation

HINT:

Use the same procedures for the LH side and RH side.
The procedures listed below are for the LH side.
A bolt without a torque specification is shown in the standard bolt chart (see SPECIFIED TORQUE FOR STANDARD BOLTS ).

INSTALL FRONT NO. 2 SPEAKER ASSEMBLY
1. Connect the connector.
2. Temporarily install the speaker by aligning the positioning pins of the speaker with the instrument panel.
3. Install the speaker with the 2 bolts.
  NOTE:
  - Do not touch the cone part of the speaker.
  - When installing the speaker to the instrument panel be careful that get caught the wires do not get caught between the parts.
    
    Fig 1: Identifying Front No. 2 Speaker Bolts
    Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL NO. 1 INSTRUMENT PANEL SPEAKER PANEL SUB-ASSEMBLY
1. Attach the 2 clips and 7 claws to install the panel.
INSTALL FRONT PILLAR GARNISH LH
INSTALL FRONT NO. 3 SPEAKER ASSEMBLY
1. Connect the speaker connector.
2. Temporarily install the speaker by aligning the positioning pins of the speaker with the instrument panel.
3. Install the speaker with the 2 bolts.
  NOTE:
  - Do not touch the cone part of the speaker.
  - When installing the speaker to the instrument panel be careful that get caught the wires do not get caught between the parts.
    
    Fig 3: Identifying Speaker With Bolts
    Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL NO. 1 SPEAKER HOLE COVER
1. Attach the 4 clips to install the hole cover.
Fig 4: Identifying Clips And Hole Cover
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
INSTALL COWL TOP VENTILATOR LOUVER RH (See INSTALLATION )
PERFORM INITIALIZATION
1. Perform initialization (see INITIALIZATION ).
  NOTE: Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.