LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2008 >> Wrangler X, Standard >> Repair and Diagnosis >> Engine Performance >> Ignition System >> Ignition Control - Electrical Diagnostics >> Ignition Control- Electrical Diagnostics >> DTC Troubleshooting >> B222C-Vehicle Configuration Not Programmed >> Diagnostic Test

Diagnostic Test

  1. CHECK FOR ACTIVE DTC 

    Turn the ignition on.

    With the scan tool, read DTCs.

    Does the scan tool display this DTC as active? 

    Yes 

    1. Go To  2.

    No 

    1. Test complete.
  2. ACTIVE TIPM DTC 

    Cycle the ignition from off to run remaining in run.

    With the scan tool, read DTCs.

    Does the scan tool display this DTC as active? 

    Yes 

    1. Go To  3.

    No 

    1. Test complete.
  3. VIN MISMATCH DTC PRESENT 

    Turn the ignition on.

    With the scan tool, read DTCs.

    Is DTC: B2206-CURRENT VIN MISSING / MISMATCH also active? 

    Yes 

    1. Refer to repair procedure for B2206-CURRENT VIN MISSING / MISMATCH .

    No 

    1. Replace the TIPM in accordance with the service information.
    2. Perform BODY VERIFICATION TEST - VER 1 .
scientia non olet · About LEMON Manuals