LEMON Manuals: Even more car manuals for everyone
Home >> Jaguar >> 1996 >> XJS >> Repair and Diagnosis >> Engine Performance >> Remove, Overhaul & Install >> Engine Controls - Remove/Install/Overhaul >> Ignition System >> Crankshaft Position Sensor >> Removal & Installation (6.0L)

Removal & Installation (6.0L)

  1. The 6.0L models are equipped with 2 Crankshaft Position (CKP) sensors. One sensor (flywheel sensor) is located at rear of engine, and other sensor (TDC sensor) is located at lower front of engine.
  2. Disconnect negative battery cable. Raise and support vehicle. Remove heat shield (if removing flywheel sensor). Disconnect sensor wiring harness connector. Remove sensor bolts and sensor. To install, reverse removal procedure.
scientia non olet · About LEMON Manuals