WITHOUT NAVIGATION : Diagnosis Procedure
- CHECK STEERING SWITCH SIGNAL A CIRCUIT
- Disconnect AV control unit connector and spiral cable connector.
- Check continuity between AV control unit harness connector terminal 6 and spiral cable harness connector terminal 33.
6 - 33 : Continuity should exist .
- Check continuity between AV control unit harness connector terminals 6 and ground.
6 - Ground : Continuity should not exist .
Is the inspection result normal?
YES: GO TO 2.
NO: Repair harness or connector.
- CHECK SPIRAL CABLE
Check spiral cable.
Is the inspection result normal?
YES: GO TO 3.
NO: Replace spiral cable.
- CHECK AV CONTROL UNIT VOLTAGE
- Connect AV control unit connector and spiral cable connector.
- Turn ignition switch ON.
- Check voltage between AV control unit harness connector terminals 6 and 15.
6 - 15 : Approx. 3.3 V
Is the inspection result normal?
YES: GO TO 4.
NO: Replace AV control unit.
- CHECK STEERING SWITCH
- Turn ignition switch OFF.
- Check steering switch. Refer to "WITHOUT NAVIGATION : COMPONENT INSPECTION ".
Is the inspection result normal?
YES: INSPECTION END
NO: Replace steering switch.