LEMON Manuals: Even more car manuals for everyone
Home >> Infiniti >> 2007 >> QX56 AWD >> Repair and Diagnosis >> Transmission >> Transfer Case >> Transfer Assembly >> Removal and Installation >> Removal

Removal and Installation: Removal

  1. Remove the drain plug and gasket. Drain the fluid. Refer to "DRAINING ".
  2. Remove the A/T undercover using power tool.
  3. Remove the center exhaust tube and main muffler. Refer to "REMOVAL AND INSTALLATION ".
  4. Remove the front and rear propeller shafts. Refer to "REMOVAL AND INSTALLATION " (front), "REMOVAL AND INSTALLATION " (rear).
    CAUTION: Do not damage spline, sleeve yoke and rear oil seal when removing rear propeller shaft.
    NOTE: Insert a plug into the rear oil seal after removing the rear propeller shaft.
  5. Remove the A/T nuts from the A/T crossmember.
  6. Position two suitable jacks under the A/T and transfer assembly.
  7. Remove the crossmember. Refer to "COMPONENTS ".
    WARNING: Support A/T and transfer assembly using two suitable jacks while removing crossmember.
  8. Disconnect the electrical connectors from the following:
    • ATP switch
    • Neutral 4LO switch
    • Wait detection switch
    • Transfer motor
    • Transfer control device
    • Transfer terminal cord assembly
  9. Disconnect each air breather hose from the following. Refer to "REMOVAL AND INSTALLATION ".
    • Actuator
    • Breather tube (transfer)
    • Transfer motor (case connector)
  10. Remove the transfer control device from the extension housing.
  11. Remove the transfer to A/T and A/T to transfer bolts.
    WARNING: Support transfer assembly with suitable jack while removing it.
  12. Remove the transfer assembly.
scientia non olet · About LEMON Manuals