Repair Procedures: Removal
WARNING: This page is about a different variant/trim than selected.
- Turn the ignition switch OFF and disconnect the battery negative (-) cable.
- Remove the air cleaner assembly (Refer to "INTAKE AND EXHAUST SYSTEM " in EM group).
- Disconnect the engine coolant temperature sensor connector (A).
- Remove the spring clip (B), and then pull the sensor from the water temperature control assembly.CAUTION:
- Note that engine coolant may be flowed out from the water temperature control assembly when removing the sensor.
- Supplement the engine coolant (Refer to "ENGINE COOLING SYSTEM " in EM group).