Removal Procedure

Fig 1: Apply Several Layers Of Masking Tape To Mirror Lower Housing Edge

Courtesy of GENERAL MOTORS CORP.

Apply several layers of masking tape (1) to the mirror lower housing edge (2) to protect the finish.

Fig 2: Insert Rigid Plastic Tool Between Mirror Lower Housing Edge And Lower Edge Of Mirror Lens

Courtesy of GENERAL MOTORS CORP.

Remove the mirror lens as follows:
1. Push the top center of the mirror inward.
2. Place your hand on the back of the mirror housing (2).
3. Use a suitable rigid plastic tool (3) 3.81 cm (1.5 in) wide. Insert the rigid plastic tool (3) 3 cm (1.5 in) between the mirror lower housing edge (4) and the lower edge of the mirror lens (5).
4. Lift upward on the rigid plastic tool (3) until the mirror lens (1) releases from the motor/actuator ring.
Disconnect the electrical connectors from the back of the mirror lens.

Fig 3: Motor/Actuator Ring Must Stay With Motor/Actuator

Courtesy of GENERAL MOTORS CORP.

The motor/actuator ring (1) must stay with the motor/actuator, not with the mirror lens (2).

Fig 4: Identifying Mirror Motor/Actuator Ring & Mirror Lens

Courtesy of GENERAL MOTORS CORP.

NOTE: When removing the motor/actuator ring, use care Not to damage the mirror lens.

If the mirror motor/actuator ring (1) stays attached to mirror lens (3), the motor/actuator ring (1) MUST be removed from the mirror lens.
1. Place the mirror lens face down on a soft cloth.
2. Remove the motor/actuator ring (1), by sliding the ring downward releasing the tabs (2) from the back mirror lens (3).