LEMON Manuals: Even more car manuals for everyone
Home >> Honda >> 2000 >> Prelude Base, Standard >> Repair and Diagnosis >> Suspension >> Wheel Alignment >> Wheel Alignment Specifications & Adjustment Procedures >> Wheel Alignment Procedures >> Camber Adjustment >> Odyssey

Camber Adjustment: Odyssey

NOTE: Front camber can be adjusted by exchanging one or both damper pinch bolts with a smaller diameter adjusting bolt (90120-S0X-A00). The difference between adjusting bolt diameter and pinch bolt hole diameter only allows for a small range of adjustment.
  1. Compare camber settings with vehicle manufacturer recommendations. See WHEEL ALIGNMENT SPECIFICATIONS  . If camber is incorrect, raise and support front of vehicle. Remove front wheels. Loosen and adjust 2 flange nuts by moving bottom of damper within range of damper pinch bolt free play. See Fig 1 . Tighten flange nuts to specifications and go to next step. See TORQUE SPECIFICATIONS  .
  2. Install front wheels and lower front of vehicle. Bounce front of vehicle several times to stabilize suspension, measure camber. If measurement is within specification, measure toe-in. See TOE-IN ADJUSTMENT  . If camber is still incorrect, go to next step.
  3. Raise and support front of vehicle. Remove front wheels. Replace damper pinch bolts with adjusting bolts and adjust camber angle to specifications. Tighten flange nuts to specifications and repeat step  2 . See TORQUE SPECIFICATIONS  . If camber is still incorrect, repeat step 2)  until measurement is within manufacturer specifications.
Fig 1: Adjusting Front Camber (Odyssey)
G00015916Courtesy of AMERICAN HONDA MOTOR CO., INC.
scientia non olet · About LEMON Manuals