LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2017 >> Traverse Premier, AWD >> Repair and Diagnosis (Single Page) >> Restraints >> Air Bag, SRS >> Supplemental Inflatable Restraint System >> Diagnostic Information and Procedures >> DTC B0081: Passenger Presence Module >> Circuit/System Testing

Circuit/System Testing

NOTE:

When removing connectors, inspect for damage or corrosion. Damage or corrosion in the following requires repair or replacement of the affected component/connector:

  • Passenger Presence Module
  • Inflatable Restraint Sensing and Diagnostic Module
  • Passenger Presence Module harness connector
  • Inflatable Restraint Sensing and Diagnostic Module wiring harness connector
  1. Ignition OFF, disconnect the harness connector at the Passenger Presence Module.
  2. Ignition OFF, test for less then 10 Ω between the ground circuit terminal 4 and ground.
    • If greater then the specified range, test the ground circuit for an open/high resistance.
  3. Ignition ON, verify a test lamp illuminates between the B+ circuit terminal 3 and ground.
    • If the test lamp does not illuminate, test the B+ circuit for a short to ground or an open/high resistance.
  4. Reconnect all Passenger Presence Module components and perform the Passenger Presence System Programming and Setup .
  5. Clear all DTCs and operate the vehicle. DTC B0081 should not set.
    • If DTC B0081 sets, replace the Passenger Presence Module.
scientia non olet · About LEMON Manuals