Installation Procedure
- Install the antenna cable to the vehicle. Use electrical tape in order to secure the antenna extension cable to the top of the wiring harness. Secure the cable to the harness at least every 150 mm (6 in).
- Connect the antenna extension cable (2) from the radio to the antenna cable (1) near the kick panel:
- Position the antenna extension cable behind the sliding lock feature.
- Install the antenna extension cable to the sliding lock feature.
- Install the carpet.
- Install the right lower center pillar trim panel. Refer to Center Pillar Lower Trim Panel Replacement .
- Install the right carpet retainers. Refer to Front Side Door Opening Floor Carpet Retainer Replacement (Impala) .
- Install the rear seat back. Refer to Rear Seat Back Cushion Removal and Installation (Impala) .
- Install the rear seat cushion. Refer to Rear Seat Cushion Removal and Installation (Impala) .
- Connect the antenna cable (1) to the radio antenna module (2):
- Position the antenna cable behind the sliding lock feature.
- Install the antenna cable to the sliding lock feature.
- Install the rear upper quarter trim panel. Refer to Quarter Upper Trim Panel Replacement .
IMPORTANT:
The antenna cable uses a sliding snap-lock. Holding the sliding lock feature will prevent installation.
IMPORTANT:
The antenna cable uses a sliding snap-lock. Holding the sliding lock feature will prevent installation.